|
||||||||
|
Home | Chrysler Inboards | Dana Stern Drives | Gelcoat Restoration | Sunbrella and other fabric | Return Policy | About US | View Cart | |
Before You buy elsewhere
Ask if they OWN and work on Chrysler boats! We OWN 4
Personal Chrysler boats and know first hand what works and
what doesn't. Some folks might say their your Marine
Parts Source but we truly own and work on them, so who's the
real SOURCE? That's us in our Chrysler boat above!
Click here for info on our
boats and the Chrysler Marine Nationals we put on!
We are TRUE CHRYSLER FANS! |
PV #66 Errors ?? | Email US! |
APPLICATION |
Do not treat Poli Glow like a wax. Apply Poli Glow, instead like a paint or varnish. It should be applied to the surface gently. Do not push down on applicator, this may cause foam or bubbles which may dry rough. Do not stop applicator, instead pull away from surface gradually. If drips occur, remove them with applicator before they dry. Avoid windy conditions. Now it is time to apply Poli Glow. This is the easy part. Apply Poli Glow to the applicator amd allow a minute to soak into applicator. Pick a small 2' x 2' flat surface to see what Poli Glow will do. Working in small sections (3-4 foot), lightly wipe Poli Glow onto the surface in thin, even, overlapping strokes. Make sure application is dry, approximately one minute at 55° - 95° F, before applying the next coat. If you go over Poli Glow before it is dry you will get brush marks. Apply a minimum of five coats. The first two or three coats may appear dull or streaky due to penetration into the fiberglass. Poli Glow may be applied in direct sunlight except with dark colors. When overlapping you may see areas that are shinier. They will disappear in 24-48 hours. Avoid contact with rain for several hours. If water spots occur they will disappear after a few hours in the sunlight. |